
HELP LINKS
HELP & ADVICE - ESSENTIAL READING
www.cravenmodels.com/HELP.htm
MINIMUM SKILLS REQUIRED
www.cravenmodels.com/SKILLS.htm
ELECTRICS TERMINOLOGY
www.cravenmodels.com/TERMINOLOGY.htm
GENERAL ELECTRICS HELP
www.cravenmodels.com/ELECTRICS.htm
ECKON BERKO SIGNALS
www.cravenmodels.com/ECKONBERKOINS.htm
CARE OF LED’S
www.cravenmodels.com/LEDSHELP.htm
THE NEW AGE OF DCC –
INFORMATION THAT YOU NEED TO CONSIDER
BEFORE PROCEEDING !!!
TOOL HANDLING & MAGNETIC WARNING
www.cravenmodels.com/WARNING.htm
HANDLING DELICATE WIRING
www.cravenmodels.com/WIREHANDLING.htm
DCC INSTALLATATION CARE & KNOWLEDGE REQUIRED
www.cravenmodels.com/DCCCARE.htm
DCC TRAINTRONICS INSTALLATION MANUAL
www.cravenmodels.com/TRAINTRONICSDCCINS.htm
DCC CONCEPTS INSTALLATION MANUAL
www.cravenmodels.com/DCCCONCEPTS.htm
MANUFACTURERS WARRANTY
www.cravenmodels.com/WARRANTY.htm
Just click on any link above
FULL PRODUCT CARALOGUE
www.modeltrainsuk.com

|
Home > SIGNALS BERKO COLOUR LIGHT OO >
FULL BERKO PRODUCT - CATALOGUE www.cravenmodels.com/BERKO.htm << click
Warranty - The warranty applies when the component is used in any reasonable application in conjunction with signal operation and control, and or point/turnout control or any similar or related model railway purposes, providing that it is installed with respect and has not been subjected to water or corrosive liquids, has been properly wired in accordance with instructions provided with the component plus any related online instructions as directed. Be operated within recommended supply voltages and power that has been supplied to it by a properly rectified power supply and or any NMRA compatible DCC decoder with a voltage and power output which meets the manufacturers specifications and that the correct polarity is observed. It is the customer’s responsibility to ensure that they have the necessary knowledge and skills to be able to correctly install the components purchased. Any damage caused to the component by the customer, is not covered by warranty. ITEMS SHOWN BELOW ARE IN STOCK - MANY ITEMS HAVE BEEN OUT OF PRODUCTION FOR OVER 6 MONTHS. WE ALSO OFFER ECKON & TRAINTRONICS SIGNALS http://www.modeltrainsuk.co.uk/signal-kits-eckon-11-c.asp << Click http://www.modeltrainsuk.co.uk/signals-traintronics-oo-30-c.asp <<Click
http://www.modeltrainsuk.co.uk/electrics-controls-switches-wires-22-c.asp << CLICK ELECTRICS CONTROLS SWITCHES
WE ARE WAITING FOR NEW DELIVERIES OF OTHER ITEMS - Tel 01588 660 580
PLEASE NOTE THAT THESE SIGNALS ARE POWERED BY 12 VOLTS DC SUPPLY ONLY. DO NOT USE ANY FORM OF AC POWER.
BERKO SIGNALS COME READY ASSEMBLED.
An Electrical power supply is required at 12 volts DC to illuminate the LED's which need to be operated with an appropriate switch. These items are not included in the kit.
Please read the instructions very carefully before attempting installation.
Special attention must be given to the operation of the LES's. DO NOT operate these items without a RESISTOR (included) in the circuit and then only with a 12 VOLT DIRECT CURRENT SUPPLY.
Children should be supervised at all times.
.
PLEASE DO NOT USE A HORNBY CONTROLLER FOR YOUR POWER SUPPLY - YOU NEED A SEPERATE 12 VOLT DC POWER SUPPLY ONLY.
.
« Back |














