Home > ECKON SIGNAL KITS OO PLUS ACCESSORIES 12V DC
12 volts DC only For Eckon/Berko Signals
PLEASE NOTE THAT THESE SIGNALS ARE POWERED BY 12 VOLTS DC SUPPLY ONLY. DO NOT USE ANY FORM OF AC POWER.
IF USING LENZ DCC SYSTEM YOU MUST USE SWITCH DECODER LS100
ECKON KITS need to be assembled using the instructions enclosed with the kit.
An Electrical power supply is required at 12 volts DC to illuminate the LED's which need to be operated with an appropriate switch. These items are not included in the kit.
Please read the instructions very carefully before attempting assembly.
Special attention must be given to the operation of the LES's. DO NOT operate these items without a RESISTOR (included) in the circuit and then only with a 12 VOLT DIRECT CURRENT SUPPLY.
The assemply of the kit of parts requires a degree of dexterity and modelling ability. Children should be supervised at all times.
PLEASE DO NOT USE A HORNBY CONTROLLER FOR YOUR POWER SUPPLY - YOU NEED A SEPERATE 12 VOLT DC POWER SUPPLY ONLY.
OTHER MODEL RAILWAY SIGNALS AVAILABLE IN “N” GAUGE:
IF AN ITEM IS NOT SHOWN BELOW IT IS NO LONGER AVAILABLE
PLEASE ONLY ORDER ITEMS THAT ARE LISTED AS BEING IN STOCK
Eckon/Berko produce a range of working British Outline colour light signals in OO Scale and N Scale.
The Eckon range is a selection of OO Scale signal kits, with a highlight being the ENES19 Kit Junction Signal 2 x 2x2-Aspect 3-Way.
The Berko range consists of pre built signals in OO and N scale. The N gauge range has now become available again after an absence, and is proving very popular as it is one of the only ready build N gauge signals available on the market. At the moment the selection is small, but the range is sure to grow. The range of signals are a good way to add extra detail to a layout.
To power these signals you will require a 12V DC supply. We recommend ether the Gaugemaster open T1 DC transformer or cased M1 DC Transformer. To control one of the signals with just a Red/Green changeover we would recommend a GM508 - A5C mini-toggle SPDt switch. If you are looking to change a signal with a 3 or 4 aspect you are going to require a GM519 A7 Rotary Switch 1 Pole 12 Way.