« Prev |1|2| Next »
ALL PRICES ARE DISCOUNTED DOWN FROM THE SUGGESTED RETAIL PRICE
IN ADDITION RECEIVE A
20% DISCOUNT OFF YOUR ORDER TOTAL
NEW CUSTOMERS - NO NEED TO LOG IN
IF AN ITEM IS NOT SHOWN BELOW IT IS NO LONGER AVAILABLE
Home > BERKO N GAUGE COLOUR LIGHT SIGNALS
PLEASE NOTE THAT THESE SIGNALS NEED TO BE POWERED BY 12 VOLTS DC very low amperage supply. DO NOT USE ANY FORM OF AC POWER.
IF USING LENZ DCC SYSTEM YOU MUST USE SWITCH DECODER LS100
The Berko range consists of pre built signals in OO and N scale. The N gauge range has now become available again after an absence, and is proving very popular as it is one of the only ready build N gauge signals available on the market. At the moment the selection is small, but the range is sure to grow. The range of signals are a good way to add extra detail to a layout.
To power these signals you will require a 12V DC supply. We recommend ether the Gaugemaster open T1 DC transformer or cased M1 DC Transformer. To control one of the signals with just a Red/Green changeover we would recommend a GM508 - A5C mini-toggle SPDt switch. If you are looking to change a signal with a 3 or 4 aspect you are going to require a GM519 A7 Rotary Switch 1 Pole 12 Way.
Warranty - The warranty applies when the component is used in any reasonable application in conjunction with signal operation and control, and or point/turnout control or any similar or related model railway purposes, providing that it is installed with respect and has not been subjected to water or corrosive liquids, has been properly wired in accordance with instructions provided with the component plus any related online instructions as directed. Be operated within recommended supply voltages and power that has been supplied to it by a properly rectified power supply and or any NMRA compatible DCC decoder with a voltage and power output which meets the manufacturers specifications and that the correct polarity is observed. It is the customer’s responsibility to ensure that they have the necessary knowledge and skills to be able to correctly install the components purchased. Any damage caused to the component by the customer, is not covered by warranty.