« Prev |1|2| Next »
RECEIVE 25% DISCOUNT OFF YOUR ORDER TOTAL
NEW CUSTOMERS - NO NEED TO LOG IN
Telephone 01588 660 425 11am - 5pm
v v v
Home > BERKO COLOUR LIGHT SIGNALS OO 12V DC
PLEASE NOTE THAT THESE SIGNALS ARE POWERED BY 12 VOLTS DC SUPPLY ONLY. DO NOT USE ANY FORM OF AC POWER.
BERKO SIGNALS COME READY ASSEMBLED.
An Electrical power supply is required at 12 volts DC to illuminate the LED's which need to be operated with an appropriate switch. These items are not included in the kit.
Please read the instructions very carefully before attempting installation.
The Berko range consists of pre built signals in OO and N scale. The N gauge range has now become available again after an absence, and is proving very popular as it is one of the only ready build N gauge signals available on the market. At the moment the selection is small, but the range is sure to grow. The range of signals are a good way to add extra detail to a layout.
To power these signals you will require a 12V DC supply. We recommend ether the Gaugemaster open T1 DC transformer or cased M1 DC Transformer. To control one of the signals with just a Red/Green changeover we would recommend a GM508 - A5C mini-toggle SPDt switch. If you are looking to change a signal with a 3 or 4 aspect you are going to require a GM519 A7 Rotary Switch 1 Pole 12 Way.
Warranty - The warranty applies when the component is used in any reasonable application in conjunction with signal operation and control, and or point/turnout control or any similar or related model railway purposes, providing that it is installed with respect and has not been subjected to water or corrosive liquids, has been properly wired in accordance with instructions provided with the component plus any related online instructions as directed. Be operated within recommended supply voltages and power that has been supplied to it by a properly rectified power supply and or any NMRA compatible DCC decoder with a voltage and power output which meets the manufacturers specifications and that the correct polarity is observed. It is the customer’s responsibility to ensure that they have the necessary knowledge and skills to be able to correctly install the components purchased. Any damage caused to the component by the customer, is not covered by warranty.
Special attention must be given to the operation of the LES's. DO NOT operate these items without a RESISTOR (included) in the circuit and then only with a 12 VOLT DIRECT CURRENT SUPPLY.
Children should be supervised at all times.
PLEASE DO NOT USE A HORNBY CONTROLLER FOR YOUR POWER SUPPLY - YOU NEED A SEPERATE 12 VOLT DC POWER SUPPLY ONLY.
IF AN ITEM IS NOT SHOWN BELOW IT IS NO LONGER AVAILABLE
PLEASE ONLY ORDER ITEMS THAT ARE LISTED AS BEING IN STOCK